User guide

Updating the Firmware 3-5
To run Options ROMPaq:
1. Locate the diskette containing the Options ROMPaq and place it into
the server floppy drive.
2. Boot the server by turning on the power.
3. Press Enter at the Welcome screen.
4. At the Select A Device screen select:
ALL COMPAQ Smart Array 431 Controller(s)
from the list of programmable devices. Press Enter.
5. If the ROM firmware in the Smart Array 431 Controller is the same or
newer than that on the Options ROMPaq diskette, this message
displays:
The ROM image files found for the device selected
are not newer than the current ROM image
Press Enter to go to step 9.
OR
If the ROM firmware in the Smart Array 431 Controller is older than
that on the Options ROMPaq diskette, the Select An Image screen
displays:
Device to reprogram: ALL COMPAQ SMART 431 Controller(s)
Current ROM revision: COMPAQ SMART 431 Controller x.xx
Select Firmware Images: COMPAQ SMART 431 Controller y.yy
Press Enter.
6. Review the information on the Caution screen:
Device to reprogram: ALL COMPAQ SMART 431 Controller(s)
Current ROM revision: COMPAQ SMART 431 Controller x.xx
Selected ROM revision: COMPAQ SMART 431 Controller y.yy
7. Press Enter to reprogram the Smart Array 431 Controller ROM or Esc
to discontinue the reprogramming and return to the Select An
Image screen.
Reprogramming Firmware
indicates that the Smart Array 431 Controller ROM is being
reprogrammed. DO NOT INTERRUPT THIS PROCESS.