User guide

Index 11
ROM
flashing 3-1
updating 3-1
upgrading H-3
ROMPaq
diskettes, creating 3-2
options
description 3-1
running 3-5
when to use 3-4
system
description 3-1
running 3-3
using 3-1, H-3
utilities
creating diskettes 3-2
running 3-2
SCO OpenServer 5
accessing 7-11
creating diskettes 7-10
driver 7-10
installing 7-10
required information 7-10
SCO UnixWare 2.1
diskettes, creating 7-12
driver information,
accessing 7-13
driver information,
obtaining 7-12
installation information,
obtaining 7-12
screens
array buttons 6-25
Array Configuration 6-22
Configuration List 6-24
Configuration View 6-14
Controller box 6-25
Controller buttons 6-9
Controller Select list 6-9
Controller Selection 6-23
Controller Settings 6-9, 6-26,
6-27
Create Array 6-10, 6-27, 6-28
Create Logical Drive 6-29
logical drive buttons 6-26
Main Configuration 6-22
More Information 6-25
NetWare, auto-configuration
wizard 6-31
NetWare, Controller
Settings 6-32
NetWare, Main Configuration
View 6-32
NetWare, rebuilding logical
drive 6-34
ORCA, Confirmation 6-4
ORCA, initial start 6-3
View Buttons 6-25
SCSI
bus, termination 4-3
Low Voltage Differential,
defined 1-5
ports
utilization 4-3
Single Ended 1-5
standards supported 1-5
transfer rates 1-5
SCSI cable connectors
identified 1-3
SCSI cabling
internal changes 4-3
internal, ProLiant servers 4-3
SCSI cabling, internal
servers 4-3
SCSI ID 4-4
assigning 2-4, H-2
drive value 4-5
hot-pluggable drives 4-4
periphals 4-4
SCSI termination C-2
requirements 4-3
SE See Single Ended
servers
internal cabling See SCSI
cabling, internal