User guide

Installing the Operating System Drivers 7-19
Limitations
■ The driver MUST be loaded by a BASEDEV= statement in the
CONFIG.SYS file. This statement is automatically inserted by the
ADDARRAY.CMD installation procedure.
■ When using the /V, verbose option, command line switch for this driver
in a system using OS/2 for SMP, the text is not reliably displayed.
Proceed to the last section in this chapter, “Updating the Compaq Insight
Management Agents.”
Updating the Compaq Insight
Manager Agents
If you are using Compaq Insight Manager, you will need to update the Insight
Agents to support the new Smart Array 431. If you used SmartStart 4.50 or
later to install the operating system on a new Smart Array 431 installation or to
upgrade your driver in an existing installation, SmartStart updated the agents.
You will not have to update the agents manually.
The correct agents can be obtained from your local Compaq Reseller or
Authorized Compaq Service Provider. Refer to the documentation included
with Compaq Insight Manager for the correct procedure for updating agents.
Installation of the Compaq Smart Array 431 is complete. Reboot the server to
begin using the array controller.