User`s manual

MKP 2000 Remote Control Panel • Quick Start Guide
Quick Start Guide — MKP 2000, cont’d
MKP 2000 Remote Control Panel • Table of Contents
Chapter 1 • Introduction .......................................................... 1-1
About the MKP 2000 Remote Control Panel ........... 1-2
RS-232 connection to the switcher ....................................... 1-3
Ethernet connection to the switcher ................................... 1-3
Application diagram.............................................................. 1-3
Chapter 2 • Installation ............................................................. 2-1
MKP Installation Overview............................................... 2-2
UL Requirements for Wall Box Installation ............. 2-3
Installation Procedures....................................................... 2-3
Preparing the site and installing the mounting bracket
(mud ring) or wall box ........................................................... 2-4
Mounting the MKP to the mounting bracket (mud ring)
or wall box ............................................................................. 2-7
Rear Panel and Side Panel Connections .................... 2-8
Control connections ............................................................ 2-10
RS-232 cable termination .............................................. 2-11
TP cable termination ..................................................... 2-12
Power supply wiring ............................................................ 2-14
Chapter 3 • Local Operation .................................................. 3-1
Front Panel Controls and Indications ......................... 3-2
Front Panel Operations....................................................... 3-3
Creating a tie ......................................................................... 3-3
Deselecting a tie .............................................................. 3-4
Viewing the last input or output tied from the MKP ......... 3-4
Viewing and configuring the IP and MKP setup
parameters ............................................................................. 3-4
Host control port setting and pass-through
communications ............................................................... 3-8
Control panel security lockout (executive mode) ................ 3-8
Rear Panel Resets .................................................................. 3-9
Performing soft resets ........................................................... 3-9
Performing a hard reset ...................................................... 3-10
Chapter 4 • SIS™ Operation ................................................... 4-1
RS-232 Links .............................................................................. 4-2
Routing matrix switcher commands ..................................... 4-2
Ethernet Link ........................................................................... 4-3
Default IP address .................................................................. 4-3
Table of Contents
QS-2
Step 10
Program the control panel with the size of the connected switcher.
See “System Settings page” in chapter 5, “HTML Operation.”
Step 11
Use the control panel to select inputs and outputs. See “Front Panel
Operations” in chapter 3, “Local Operation.”
i