User`s manual

MKP 2000 Remote Control Panel • SIS
™
Operation
MKP 2000 Remote Control Panel • SIS
™
Operation
SIS
™
Operation, cont’d
4-10 4-11
Command/response table for MKP SIS commands (continued) Command ASCII Command Response Additional description
(host to MKP) (MKP to host)
Verbose mode
Set verbose mode on
Esc
X9
CV Vrb1 The MKP reports all status changes to the device
that sent the command.
Read verbose mode
Esc
CV
X9
Read connection’s security level
Esc
CK
X10
Password level protection assigned.
RS-232 port configuration
Configure serial port
Esc
X2
*
X11
,
X12
,
X13
,
X14
CP
Cpn
X2
• Ccp
X11
*
X12
*
X13
*
X14
Example:
Esc
1 * 9600,n,8,1CP
Cpn01 • Ccp9600,N,8,1
9600 baud, no parity, 8 data bits, 1 stop bit.
View port configuration
Esc
X2
Cp
X11
*
X12
*
X13
*
X14
Disable/enable inputs and outputs
Enable all inputs
Esc
+7BM Upl Enable all inputs.
Disable all inputs
Esc
+6BM Upl Disable all inputs.
Enable all outputs
Esc
+9BM Upl Enable all outputs.
Disable all outputs
Esc
+8BM Upl Disable all outputs.
Input and output enables can be read using SIS commands, but the returned data is hard to interpret. Reading the enabled outputs is far simpler using the HTML pages. See “System Settings page” in chapter 5, “HTML Operation.”
Command/response table for MKP SIS commands (continued) Command ASCII Command Response Additional description
(host to MKP) (MKP to host)
Information requests
Information request I MKP • 2000 Report model name.
Request for part number N 60-682-00
See appendix A for part numbers.
Query firmware version Q
X6
Show firmware version
X6
in format x.xx.
Query verbose firmware version 0Q
X7
Provide a detailed status of the Ethernet protocol
firmware, the MKP controller firmware, and any firmware upgrade. The firmware that is running is marked by asterisk (*). A caret (^) indicates that the firmware has a bad checksum or an invalid load. ?.?? indicates that firmware is not loaded.
Response description: Ethernet protocol firmware version - controller firmware version - updated firmware version
Query status S
X8
Show voltage and temperature readings.
Resets
The Names Reset command (
Esc
ZXXX ) has no affect on an MKP 2000, but it can be applied from a primary MKP 2000 to one or
more connected MKP 3000s.
Names reset
Esc
ZXXX Zpx Erase all presets, preset names, input names, and
output names.
Absolute reset
Esc
ZQQQ Zpq Perform a Names reset plus restoring all IP settings.