Data Sheet

IDC7 Bluetooth Module
Model: IDC747
Page: 18 Copyright IOT747 Ref: IDC747-DTS-V003
IOT747, 122 Ross Street, Cambridge, CB1 3BU, United Kingdom
Check www.iot747.com for updates. Email: [e-mail] Back to TOC
IDC747 Module
Product Information Data Sheet
Ref: IDC747-DTS-V003
Latest Update: July 20, 2021
122 Ross Street, CB13BU
Cambridge, United Kingdom
www.iot747.com
Regulatory Certifications
The module is delivered with FCC, CE and Bluetooth SIG certifications. This allows to integrate the module in
an end product without the need to obtain subsequent and separate approvals from these regulatory agencies.
This is valid in the case no other intentional or un-intentional radiator components are incorporated into the
product. Without these certifications, an end product cannot be marketed in the relevant regions.
United States - FCC
In case no other intentional or un-intentional radiator is incorporated, the module's FCC certification allows
users to integrate the module into products without the need to obtain subsequent and separate approval.
The module is supplied approved as "intentional transmitter radio module" by the United States' Federal
Communications Commission (FCC) with accordance to CFR47 Telecommunications Part 15, Subpart C,
section 212. This certification is applicable in all the states in the United States.
The certification allows products to be listed in the NRTL (National Recognized Test Laboratory) as appointed
by OSHA (Occupational Safety and Health Administration).
Label and Documentation:
The module has been labelled with its own FCC ID number. In order to the extend the certification granted to
the module, its FCC ID number must be displayed on the finished product in which the module is integrated.
The following wording should be used "Contains Transmitter Module FCC ID: 2A3WYID7 or “Contains FCC ID:
2A3WYID7”.
RF Exposure Compliance:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Notice to OEM integrator
If the FCC ID is not visible when the module is installed inside another device, then the outside of the device into
which the module is installed must also display a label referring to the enclosed module. The end product shall
haves the words “Contains Transmitter Module FCC ID: 2A3WYID7”.
The device must be professionally installed.
The intended use is generally not for the general public. It is generally for industry/commercial use.
The connector is within the transmitter enclosure and can only be accessed by disassembly of the transmitter
that is not normally required.
The user has no access to the connector.
Installation must be controlled. Installation requires special training.
Any company of the host device which installs this modular with unlimited modular approval should perform the
test of radiated &conducted emission and spurious emission, etc. according to FCC part 15C: 15.247 and15.209
& 15.207, 15B Class B requirement, only if the tests result comply with FCC part 15C: 15.247 and 15.209 &
15.207, 15B Class B requirement, then the host can be sole legally.
When the module is installed inside another device, the user manual of the hose contain below
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may cause undesired operation
FCC standards: FCC CFR Title 47 Part 15 Subpart C Section 15.247 : Chip Antenna with gain 0dBi
The user-manual for any product in which the module is integrated in must include the following statements:
Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.