Installation guide

Image 11!
!
Hardware Set-up!
Once you have successfully installed the software you you will need to connect your
hardware and configure it for use. Begin by connecting the small “D”-shaped end of
the USB cable to the SnapShell IDR and then connect the USB cable from your scanner
to the computer. The scanner is now installed and ready for use.!
!
NOTE: DO NOT CONNECT THE PRINTER TO A USB KEYBOARD OR OTHER HUB AS THE
POWER SUPPLIED BY THESE DEVICES IS INSUFFICIENT.!
!
KeepnTrack Configuration!
You will need to enable the ID Scanner for all operators that will be using the ID
Scanner. First, log into KeepnTrack Administration. Under the Manage tab select the
Operators sub-tab and perform a find for one of the operators that will be using the
scanner. Select that user from the results list on the left. Unlock the record and select
the Permissions sub-tab. Expand the Devices area.!
!
KeepnTrack has several settings available which allow you to customize how the ID
scanner performs at your facility. These controls can be modified independently for
each operator as desired (Image 12). !
!
1. ID Scanner is Enabled: This control allows you to hide the SCAN ID button on the
Kiosk.!
2. Show Scanner State Menu in Kiosk: This control allows you to enable the state
issuing ID control at a kiosk.!
3. Default ID Scanner State: This control allows you to select which state is set by
default when scanning ID’s. Auto Detect is the default setting.!
4. Enable ID Scanner Maintenance: This control will display maintenance options to
calibrate or clean the Scanshell 800R and Scanshell 800DX.!
IG0073.5 — V6451 Driver’s License Camera Scanner Page ! of 158