Installation guide

Summary of Installation Steps!
In order to use your scanner with KeepnTrack, you must first properly install the
hardware and device drivers before configuring the scanner software:!
!
1. Install the scanner on your computer by installing the required software and then
plug in the scanner to set up the hardware.!
!
NOTE: DO NOT PLUG THE SCANNER INTO THE COMPUTER UNLESS PROMPTED BY THE
SOFTWARE OR THE INSTALLATION PROCESS IS COMPLETE.!
!
2. Configure the KeepnTrack Administration Settings to use a scanner.!
!
3. Finally, configure the KeepnTrack Kiosk to use your scanner. This step may
require changing some of the default settings in your browser. For more information
see the Browser Settings section toward the end of this guide.!
!
These steps will be covered comprehensively below.!
!
Before using your scanner to you must install the scanner software. The software can
be found on the installation CD provided. Locate and Run the file named
sdk_setup.exe to launch the installer (Image 2 & Image 3).!
!
NOTE: THE SOFTWARE COMPONENTS MAY ALSO BE DOWNLOADED FROM:!
http://www.keepntrack.com/support_downloads.html!
!
Image 2!
!
!
IG0073.5 — V6451 Driver’s License Camera Scanner Page ! of 153