Installation guide
!
NOTE: YOU MUST HAVE INTERNET EXPLORER 8 OR GREATER INSTALLED TO USE THE
DRIVERS LICENSE SCANNER WITH KEEPNTRACK. THIS SCANNER IS ONLY SUPPORTED
ON INTERNET EXPLORER.!
!
Setting up the scanner!
When unpacking, verify that you have received the scanner, manual, installation CD,
calibration card, cleaning fabric, and a USB cable. If any components are missing,
contact COMPanion Technical Support at 1-800-320-5830 or
support@keepntrack.com!
!
Summary of Installation Steps!
In order to use your scanner with KeepnTrack, you must first properly install the
hardware and device drivers before configuring the scanner software:!
!
1. Install the scanner on your computer by installing the required software and then
plug in the scanner to set up the hardware.!
!
NOTE: DO NOT PLUG THE SCANNER INTO THE COMPUTER UNLESS PROMPTED BY THE
SOFTWARE OR THE INSTALLATION PROCESS IS COMPLETE.!
!
2. Configure the KeepnTrack Administration Settings to use a scanner.!
!
3. Calibrate the scanner.!
!
4. Finally, configure the KeepnTrack Kiosk to use your scanner. This step may
require changing some of the default settings in your browser. For more information
see the Browser Settings section toward the end of this guide.!
!
These steps will be covered comprehensively below.!
!
System Requirements
Windows
Minimum
Windows XP SP2!
(32-bit)!
1 GB Free Hard Drive Space, 1 GB RAM, USB 1.1
connection !
Internet Explorer 8!
Recommended
Windows 7 or Windows 8 !
(32 or 64 bit)!
20 GB+ Free Hard Drive Space, 2 GB+ RAM, USB
2.0 connection!
Internet Explorer 10
IG0069.3 - V6450 Driver’s License Optical Scanner Page ! of 152