User manual
Table Of Contents
- Introduction
- Installation
- Monitoring the multifunction terminal
- MF Director
- MF Monitor
- Printing
- Analyzing a document
- The Address book
- Fax communication
- SMS communication
- Optical Character Recognition (OCR) program
- 24 -
Identify the connectors of your USB cable, and connect them.
Turn your multifunction terminal on.
The add device wizard is displayed.
Click NEXT.
Select FIND THE APPROPRIATE DRIVER FOR MY DEVICE (RECOMMENDED). Click
N
EXT.
Select the location where the system is to look for the driver. Only check the CD-
ROM
DRIVES box if the Windows asks where the drivers are located. Click NEXT.
The search takes a few moments.
A window indicates that the driver has been found. Click NEXT.
A window tells you that the software has been installed. Click FINISH.
If the Wizard is displayed again, refer to the third step of this procedure and
follow the instructions. This procedure has to be carried out a total of three
times.
You can now use the multifunction terminal to print or scan your documents.