User Manual

Page 13
environment. This equipment should be installed and operated with a minimum distance of 20
centimeters between the radiator and your body.
ISED Notice
Required End Product Labeling
Any device incorporating this module must include an external, visible, permanent marking or label
which states: “Contains IC : 2533B-RXMG1”
Obligation d'étiquetage du produit final:
Tout dispositif intégrant ce module doit comporter un externe, visible, marquage permanent
ou une étiquette qui dit: "Contient IC : 2533B-RXMG1”
Test Modes
Compal Electronics, Inc. uses various test mode programs for test set up which operate separate from
production firmware. Host integrators should contact Compal Electronics, Inc. for assistance with test
modes needed for module/host compliance test requirements.
The OEM integrator has to be aware not to provide information to the end user regarding how to install
or remove this RF module in the user’s manual of the end product which integrates this module. The end
user manual shall include all required regulatory information/warming as shown in User manual.
In the end product, the antenna(s) used with this transmitter must not be co-located or operation in
conjunction with any other antenna or transmitter except in accordance with FCC multi-transmitter
product procedures. User and installers must be provided with antenna installation instructions and
transmitter operating conditions for satisfying the RF exposure compliance.