Specifications

Chapter 2-18
Set User Password / Set Administrator Password
Enter This field always shows the message.
While these fields are highlighted and press ′Enter′, a window similar to the following is
shown:
Set Administrator Password
Enter New Password [ ]
Confirm New Password [ ]
If there is an old password then setup will prompt with the following window instead and a
current password will be required to be entered at first:
Set Administrator Password
Enter current password [ ]
Enter New Password [ ]
Confirm New Password [ ]
User can now type password in field ″Enter New Password″, and re-enter password in field ″
Confirm New Password ″ for verification.
If the verification is OK:
Setup Notice
Changes have been saved.
[ continue]
The password setting is complete after user presses enter.
If the current password entered does not match the actual current password:
Setup Warning
Invalid password
Re-enter Password
[ continue]
If the new password and confirm new password strings do not match:
Setup Warning
Password do not match
Re-enter Password
The format of the password is as follows:
Length No more than 8 characters.