User's Manual

menus. To set the Supervisor password, highlight this field
and press [Enter].
Type the password and press the [Enter] key. You can type
up to ten alphanumeric characters. Symbols are ignored.
To confirm the password, type the password again and
press the [Enter] key. The supervisor or user password is
now set, and now you can choose when to verify the
password – either when you the boot the system, or when a
person enters Setup.
To change or clear a password, enter the submenu again.
You will need to enter the Supervisor password, after which
you can create a new one or set the password verification
options.