User's Manual

FCC RF EXPOSURE INFORMATION

Read this information before using your handset



In August 1996 the Federal Communication Commission (FCC) of the United States with

its action in Report and Order FCC 96-326 adopted an updated safety standard for human

exposure to radio frequency (RF) electromagnetic energy emitted by FCC regulated

transmitters. Those guidelines are consistent with the safety standard previously set by

both U.S and international standards bodies. The design of this phone complies with the

FCC guidelines and these international standards. Use only the supplied or an approved

antenna. Unauthorized antennas, modifications, or attachment s could impair call quality,

damage the phone, or result in violation of FCC regulations.



Do not use the phone with a damaged antenna. If a damaged antenna comes into contact

with the skin, a minor burn may result. Please contact your local dealer for replacement

antenna.

 Any changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

 This device complies with part 15 of the FCC Rules. Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

 This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

- Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help