User's Manual

10
BATTERY INFORMATION
Your phone comes with a partially charged, rechargeable Li-ion battery so that you can use the
phone immediately after it is activated.
Installing the Battery.
To insert the battery into your phone:
1. Remove the battery compartment cover of the phone by sliding it down.
2. Put the battery pack into the battery cradle.
3. Replace the battery compartment cover by sliding it up towards the phone.
4. Charge the battery pack for at least 3 hours prior to using it.
Charging the Battery.
You can tell whether or not your battery needs to be recharged by checking the upper-right
corner of your phone’s display.
When the battery charge level gets low, the battery sensor will let you know by blinking the
battery icon and making audible warning tone. If the battery level gets too low, the phone will
be turned off automatically. When this happens while you were receiving incoming call or
making outgoing call, the call will be automatically disconnected. Watch the battery strength
icon and make sure your battery is adequately charged to avoid such situation.
Charging with the Trav eler’s Charger.
Use traveler ’s charges certified only. Using any other unauthorized accessories may be
dangerous and will invalidate the phone warranty if said accessories caused damage or defected
the phone.
To Charge the Battery using the Traveler’s Charger:
- Plug the power cord of the charger into a wall outlet.
- Insert the connector of the charger at the bottom of the phone.
- Charging status will be shown on the display.
- Note) Make sure you put the connector of the charger into the phone correctly.