User's Manual

11
If you charge the battery while it is attached to your phone, a green LED on the charger denotes
that the battery has completed its charge cycle.
A completely discharged standard battery recharges fully in approximately tbd hours. The
extended battery recharges in approximately tbd hours. Leaving your phone powered on during
charging, or charging batteries simultaneously, increases charging time. Leaving the battery in
the charger once it is fully charged does not harm the battery.
Turning your phone on and off.
When you’re ready to turn your phone on, fully extend the antenna for best reception. Press and
hold “END/
” until the LED comes on and the phone sounds. When the phone has found a
signal, the “
” icon appears. Once the phone is on, it enters Standby mode, which is the
phone’s idle state. You can make and receive calls now.
To turn your phone off, press and hold “END/
” until the LED comes on and the phone sounds,
then the display will goes blank. When the phone is turned off, nothing is displayed on the
screen.
Note : If “END/
” is pressed for less than one second, the phone will not turn off. This helps
your phone from being turned off accidentally.
Standby mode.
Standby is the most basic state of your phone. The phone goes into standby mode soon after you
turn it on, or whenever you briefly press “END/
”. When your phone is in Standby mode, you
will typically see the banner (that’s the message displayed when you turn on your phone). If you
enter a phone number, you can press “SEND” to dial it, or press “SMS key (
…
)”to save it in the
internal phone book.
Power Save mode.
Your phone comes with a Power Save feature that will automatically be activated if your phone
is unable to find a signal after 15 minutes of searching. While this feature is active, the phone’s
battery charge is conserved.
The phone will automatically recheck for a signal periodically. To manually force the phone to