User's Manual

Basic Operation
39
introduce the multiparty operation steps in common use as
below:
1. Make a call until it is connected first (or when you are
receiving an incoming call). Next, make a second call while you
are already in a call.
2. When the two dialed calls are both connected, you can move
the cursor and press
to swap between the two
connected calls. When “Swap” function is activated, one call is
on line and another is on hold.
3. You can connect a call on hold to the currently active call to
form a multiparty call by select “Conference”.
4. When you assign a call and press
to select “End
Single”, it means that the handset will terminate the active call.
5. If you want to terminate all active call, press
to select
“End All”.
6. When the multiparty call is active, you can press
to
select “SMS” to edit and send a short message, or to select
“Phone Book” to view phone book list.
.
7. Press
and select “Sound Recorder” allows you to
record the conversation of the active multiparty.
8. The other part in the multiparty can hear your voice when you
turn on “Mute” function.
9. When DTMF tones are turn on during a call, it allows your
handset to make use of an automated switchboard.
10. To put the multiparty call on hold and only connect one party,