User's Manual

Chapter 2 Motion M1200 and M1300 Tablet PC Hardware
Motion Computing M1200 and M1300 Tablet PC User Guide 14
ACCESSORIES You can order the following accessories from the Motion Computing
website at www.motioncomputing.com/accessories.
NOTE: You should order the Motion M-Series FlexDock, batteries, and Digitizer
Pens from Motion Computing.
Motion M-Series Desktop Stand
The Motion M-Series Desktop Stand is an easel-like device that holds either
Tablet PC in portrait or landscape mode. You can open the desktop stand to
different widths to change the display angle: the wider you open the stand,
the more the Tablet PCs will tilt back.
Some connectors may interfere with the unit when it’s in a Desktop Stand. If
you regularly connect several accessories to your Tablet PC, consider
obtaining a Motion M-Series FlexDock.
Motion M-Series FlexDock
The Motion M-Series FlexDock is a desktop docking station that provides a
convenient interface at your desktop for either Tablet PC. It contains
interfaces for RJ-45/Ethernet, three USB connectors, a IEEE 1394
connector, headphone and microphone jacks, and a VGA monitor connector.
These are shown in the diagram below.
• Easily docks and undocks with either Tablet PC
• Automatically senses and adjusts the display when you rotate the
Tablet PC 90
o
between Primary Landscape and Primary Portrait.
• Adjusts to support the display from 0
o
- 90
o
for viewing and writing
• “Grab-and-Go” capability lets you safely remove the Tablet PC from
the FlexDock without turning the system off or putting it in Stand By
mode.
NOTE: For more information about installing the FlexDock, see Chapter 4 of this
User Guide or the Installation Card packaged with the FlexDock.
External
Monitor
RJ-45/
Ethernet
USB
A
C Power Jack
IEEE 1394
Audio-in/
Microphone
Jack
USB
Front
Motion M-
S
eries FlexDock
Back
Audio-out/
Headphone
Jack
US
B