User's Manual

3. LED Descriptions

LED indicates the different status of connection:

Status Function

Off Power off

Steady red Connected to Access Point, or, being under 802.11 Ad Hoc mode

(either connected or disconnected).

Flashing red Searching for the Access Point (disconnected)

4. Wireless LAN Module Power

1. To connect to the Wireless Network, make sure the Wireless LAN Switch is turned on.

(The default setting is Power Off. Press the switch to the left to turn the power on.)

2. If this is your first time turning on the switch, IP Address Page will pop up for you to set the

IP address, Subnet mask and Default gateway.