User's Manual

Mode allows your Pocket PC to form its own local network where devices communicate peer-

to-peer, using a shared SSID, without Access Points. Under 802.11 Ad Hoc mode, the SSID

must be the same among stations so that the devices can communicate properly within the

Wireless Network. If you want to form your network without any Access Points, you should

choose 802.11 Ad Hoc mode.

B6: Could I use the 802.11 Ad Hoc Mode to access the LAN resources? How can I access the

LAN resource without an Access Point?

Yes , you can access the LAN resources without an Access Point . Follow the steps shown

below:

(1) Make sure your host computer already successfully connect to the LAN or Internet

through the LAN Adapter or the Modem.

(2) Install the Wireless LAN Adapter into your Host computer successfully and set 802.11 Ad

Hoc Mode and the proper SSID to form the 802.11 Ad Hoc Network. Install and enable the

ICS (Internet Sharing Software, such as "SyGate"...) function in your host computer. (Note

that the Windows 2K or later version, OS, supports the ICS function in Local Area

Connection Properties→ Sharing)

(3) Set your Pocket PC as 802.11 Ad Hoc Mode and choose the same SSID to join the 802.11

Ad Hoc Network (choose the DHCP to get the IP assigned).

(4) Check and make sure the Wireless LAN Adapter in the 802.11 Ad Hoc Network have the

same IP group. (Please Ping each other to make sure the connection is successful)

(5) Now you can access the LAN resource successfully.

B7: What should I do if my host computer cannot wirelessly connect with my Pocket PC?

(1) Make sure you have setup the partnership for your Pocket PC and your host computer.

(2) Make sure you are within the range of a working network.

(3) Make sure you have entered the IP address of the host computer as the WINS server on

your Pocket PC.

(4) Reset your Handheld PC or Pocket PC to make the TCP/IP settings take effect

(5) Make sure the SSID, WEP keys and channel for all devices in the network are set the

same.

(6) Make sure the channel been set is in the range of 1~11.

C. Application

C1. What should I do to use the ActiveSync Function through Wireless Network?

(1) Make sure you have already setup the partnership for your Pocket PC and your host

computer through USB Interface and the ActiveSync can work properly. (The ActiveSync

connection Interface should also choose the Ethernet interface for Wireless LAN

ActiveSync Connection)

(2) Make sure you are within the range of a working Wireless Network.