User's Manual

5.5 Advanced Page

Use Advanced page to view and edit Power Saving Mode, Transmission Rate and Wired

Equivalent Privacy (WEP).

Click Start→Settings→System→Wireless LAN Utility→Advanced

! Wired Equivalent Privacy (WEP)

" Mode:

The default WEP Mode setting is“Disable”. You can choose “64 bits (ASCII)”,

“128 bits (ASCII)”, “64 bits (HEX)” or “128 bits (HEX)” manually to enable the

WEP or choose “Disable” to disable the WEP.

" Disable:

If there is no security issue concerned, choose “Disable” which may increase the Data

Transmission Rate.

" 64 bits (ASCII):

If WEP of the Access Point or Peer site station is set as “64 bits (ASCII)”, in Mode

field, select “64 bits(ASCII)” to connect with the Access Point or the Peer site station

by using the same 5 ASCII characters.

" 128 bits (ASCII):

If WEP of the Access Point or Peer site station is set as “128 bits (ASCII)”, in Mode

field, select “128 bits (ASCII)” to connect with the Access Point or the Peer site

station by using the same 13 ASCII characters.

" 64 bits (HEX):

If WEP of the Access Point or Peer site station is set as “64 bits (HEX)”, in Mode

field, select “64 bits (HEX)” to connect with the Access Point or the Peer site station

by using the same 10 hexadecimal values in the following range: 0~9, A(a) ~F(f).

" 128 bits (HEX):

If WEP of the Access Point or Peer site station is set as “128 bits (HEX)”, in Mode