User's Manual

function of the average frequency of both interfering frequencies.

Average frequency of interferers max. level of each interferer,

<1.0GHz -6dBm

1.0-2.0 GHz -10dBm

2.0-2.35 GHz -26dBm

2.55-2.9 GHz -26dBm

>2.9 GHz -10dBm

Table 1. Out of band maximum interference levels.

3.3.6. Irreducible Frame Error Ratio

The Irreducible FER (1024 byte frames) in an RF-clean environment (anechoic chamber) at nominal temperature between two Network

Interfaces one meter apart using 2Mbit/s DQPSK will be better than 1*10

-8

4. RF channel frequencies

The Network Interface in the 2.4-2.5GHz ISM band uses the channel center frequencies as defined by the IEEE802.11 PHY standard

for DSSS. These channel frequencies and the countries of application are listed in Table below. Note: the mini PCI card uses subset

channel 1 through 11, which allows usage across the world.

Channel ID FCC Channel

Frequencies (MHZ)

ETS Channel

Frequencies (MHZ)

Japan Channel

Frequencies (MHZ)

France Channel

Frequencies (MHZ)

1 2412 2412 - -

2 2417 2417 - -

3 2422 2422 - -

4 2427 2427 - -

5 2432 2432 - -

6 2437 2437 - -

7 2442 2442 - -

8 2447 2447 - -

9 2452 2452 - -

10 2457 2457 - -

11 2462 2462 - -

RASUI

The MTBF is 150,000 hours based on a workload of 2040 hours/year. This assumes the card does not exceed its ambient

temperature ceiling of 60 degrees C.