User's Manual

2-
When Windows has finished the copying of files, it will prompt you to restart your computer. Click the
OK
button to restart your
computer.
After Restarting Your Computer 2
After you have restarted your computer, the Windows operating system will detect the Mini-PCI Card. Load the driver, in a dialog box
enter a Windows user name and password. The password you enter here will be the one used to login to the Windows Network
Neighborhood.
2-21
Installation for Windows - Finish the Installation
Mini-PCI Card Hardware Specification
1. Operating and Storage Environment
The Network Interface Card shall be capable to pass the environmental tests as specified in “Mini PCI Specification, October 1999 [Ref.
16], Section 5.6 Thermal Guidelines”.
Operating temperature range: 0°C to 60°C ambient temperature.
.Relative humidity when operational: 95% maximum (non condensing).
Storage temperature range: -20°C to 75°C ambient temperature.
Relative humidity during storage: 95% maximum (non condensing).
2. Power supply
The Network Interface Card shall be capable to operate from 3.3V +/- 0.2V Host supply voltage. Refer to chapter 11.1. Host interface for
configuration of card type and supply voltage. The current consumption averaged over 1s is defined for the following operational
modes:
Doze mode: 30mA
Receive mode: 230mA
Transmit mode: 330mA
A 120mV peak-peak ripple on the supply voltage with a fundamental frequency not greater than 150kHz and not less than 60Hz shall
not degrade the Network Interface performance.
The total load capacitance of the supply voltage shall not exceed 150µF in order to meet the inrush current requirement.
3. PERFORMANCE REQUIREMENTS
3.1. General
Receiver input levels and transmitter output levels are specified at the antenna connector.
3.1.1. Antenna port impedance
The nominal antenna port impedance is 50W.
The Network Interface Card shall not be damaged for any Voltage Standing Wave Ratio (VSWR) 1≤VSWR≤∞.
3.1.2. Power-on start-up time
The Network Interface Card shall be operational within 600ms after switching the power supply on. This includes a delay of
max 500 ms for the Flash ROM power up sequence.
3.1.3. Doze to receive mode start-up time
The Network Interface Card shall be operational within 0.75ms after switching from Doze mode to Receive mode. This
includes lock-in and stabilization of the synthesizers. Transmissions are not allowed during this period.
3.1.4. Receive to transmit turnaround time
The time from transition of the TXE control line (transmit enable control line from WMAC to DSP) from inactive state to
active state until the RF section is in transmit mode shall be not more than 5µs. The NIC is said to be in transmit mode at the
moment the RF output power level is within 90% of its final value.
3.1.5. Transmit to receive turnaround time
The time from transition of the TXE control line (transmit enable control line from WMAC to DSP) from active state to