Operating instructions

STUDER Innotec COMPACT
COMPACT V6.8.0 16/83
delivering energy
4 Program
Program mode for
Aux. Contact
5
Contact
active
Auxiliary Contact is
activated
6
Contact
manual
Aux. Cont.
manually activated
7 TRANSFER
Transfer system is
active. In- coming
voltage is being
sent directly to AC
OUT outlet
Transfer (bypass) is disabled (see
chap. 4.7)
8 AC OUT
There is a voltage
at the AC OUT
outlet
The Inverter is in Standby-Mode
9
INVERTER
Inverter is working
Forced Inverter Mode (see chap. 4.5)
10 Over Temp.
For the time being
the COMPACT is
out of service
because of
overheating.
11 Overload
The COMPACT is
out of service
because of
overload or short-
circuit
12
Batt.
Low/High
Battery voltage is
too low
Battery voltage is or was to high
13 OFF
COMPACT is
turned off. Turning
it back on is only
possible manually.
COMPACT is for the time being
turned off. Turning it back on will
follow automatically!
14 EQUALIZE
Battery equalizing
is set
15–18
State of charge of
the battery
LED 15 – Absorption time is running
25
POWER
MONITOR
Display the value of the output power in % of Pnom (in
Inverter Mode) and the charge current in Amps (in Charger
Mode). In this mode the red LED indicates that power
sharing is in use (>100A).
4.3 Push buttons
19 ON/OFF
Turning the COMPACT on and off (Help Button for
Programming)
20
RESET
Alarm Signal off (Help Button for Programming)
21
Aux. Contact
Control Aux. contact (Help Button for Programming)
4.4 Turning Knobs