User's Manual

9. Certification Information
Brand Name: Comosia Co.,Ltd.
Address: #504-1, Business Incubator, 545, Seobu-ro, Uijeongbu-si, Gyeonggi-do, 11618, Korea
Tel: [phone]
Product name: BLE module
Model number: COMO-N832C
FCC IC : 2AXON-COMO-N832C
Manufacturer / Country of Origin: Comosia Co.,Ltd / Korea
10. Label
FCC ID label on the final system must be labeled with "Contains FCC ID : 2AXON-COMO-N832C " or : Contains
transmitter module FCC ID : 2AXON-COMO-N832C "
Caution: Any changes or modifications in construction of this device which are not expressly approved by the responsible
for compliance could void the user's authority to operate the equipment.
NOTE: This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions;
1. This device may not cause harmful interface, and
2. This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B Digital Device, pursuant to Part 15 of the
FCC Rules. These limits are designed to this equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the radio or television off and on,
the user is encouraged to try to correct interference by one or more of the following measures.
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on another circuit.
4. Consult the dealer or an experienced radio/TV technician for help.
The module is limited to OEM installation ONLY.
OEM integrators are responsible for ensuring that the end-user has no manual instructions to remove or install module.
This module is intended for OEM integrator. The OEM integrator is responsible for the compliance to all the rules that
apply to the product into which this certified RF module is integrated. Additional testing and certification may be necessary
when multiple modules are used.
In the users manual of the end product, the end user has to be informed to keep at least 20 cm separation with the
antenna while this end product is installed and operated. The end user has to be informed that the FCC radio-frequency
exposure guidelines for an uncontrolled environment can be satisfied.