Installation Manual

INS_RLXE4GE24MODMS_REV– 1 Jul 2016 PAGE 82
INSTALLATION AND OPERATION MANUAL RLXE4GE24MODMS
TECH SUPPORT: 1.888.678.9427
2. Ethernet Ethernet Type Valid Ethernet type can have a value within 0x600-0xFFFF or ‘Any’ but
excluding 0x800(IPv4) and 0x86DD(IPv6), default value is ‘Any’.
3. LLC SSAP Address Valid SSAP(Source Service Access Point) can vary from 0x00 to 0xFF or
‘Any’, the default value is ‘Any’.
DSAP Address Valid DSAP(Destination Service Access Point) can vary from 0x00 to
0xFF or ‘Any’, the default value is ‘Any’.
Control Valid Control field can vary from 0x00 to 0xFF or ‘Any’, the default value is ‘Any’.
4. SNAP PID Valid PID(a.k.a Ethernet type) can have value within 0x00-0xFFFF or ‘Any’, default
value is ‘Any’.
5. IPv4 Protocol IP protocol number: (0-255, TCP or UDP) or ‘Any’.
Source IP Specific Source IP address in value/mask format or ‘Any’. IP and Mask are in
the format x.y.z.w where x, y, z, and w are decimal numbers between 0 and 255. When
Mask is converted to a 32-bit binary string and read from left to right, all bits following
the first zero must also be zero.
DSCP Diffserv Code Point value (DSCP): It can be a specific value, range of values or
‘Any’. DSCP values are in the range 0-63 including BE, CS1-CS7, EF or AF11-AF43.
IP Fragment Ipv4 frame fragmented option: yes|no|any.
Sport Source TCP/UDP port(0-65535) or ‘Any’, specific or port range applicable for IP
protocol UDP/TCP.
Dport Destination TCP/UDP port(0-65535) or ‘Any’, specific or port range applicable for
IP protocol UDP/TCP
6.IPv6 Protocol IP protocol number: (0-255, TCP or UDP) or ‘Any’.
Source IP IPv6 source address: (a.b.c.d) or ‘Any’, 32 LS bits.
DSCP Diffserv Code Point value (DSCP): It can be a specific value, range of values or
‘Any’. DSCP values are in the range 0-63 including BE, CS1-CS7, EF or AF11-AF43.
Sport Source TCP/UDP port:(0-65535) or ‘Any’, specific or port range applicable for IP
protocol UDP/TCP.
Dport Destination TCP/UDP port:(0-65535) or ‘Any’, specific or port range applicable
for IP protocol UDP/TCP.
Action
Parameters
Class QoS class: (0-7) or ‘Default’.
DP Valid Drop Precedence Level can be (0-1) or ‘Default’.
DSCP Valid DSCP value can be (0-63, BE, CS1-CS7, EF or AF11-AF43) or ‘Default’.
‘Default’ means that the default classified value is not modified by this QCE.