Installation Manual

INS_RLXE4GE24MODMS_REV– 1 Jul 2016 PAGE 77
INSTALLATION AND OPERATION MANUAL RLXE4GE24MODMS
TECH SUPPORT: 1.888.678.9427
Queue Policing
This page allows you to configure the Queue Policer settings for all switch ports.
Label Description
Port The port number for which the configuration below applies.
Enable(E) Controls whether the queue policer is enabled on this switch port.
Rate Controls the rate for the queue policer. The default value is 500. This value is restricted
to 100-1000000 when the “Unit” is “kbps”, and it is restricted to 1-3300 when the “Unit”
is “Mbps”. This field is only shown if at least one of the queue policers are enabled.
Unit Controls the unit of measure for the queue policer rate as kbps or Mbps. The default
value is “kbps”.
This field is only shown if at least one of the queue policers are enabled.
Port Scheduler
This page provides an overview of QoS Egress Port Schedulers for all switch ports.
Label Description
Port The logical port for the settings contained in the same row.
Click on the port number in order to configure the schedulers.
Mode Shows the scheduling mode for this port.
Qn Shows the weight for this queue and port.