Installation Manual

INS_RLXE4GE24MODMS_REV– 1 Jul 2016 PAGE 76
INSTALLATION AND OPERATION MANUAL RLXE4GE24MODMS
TECH SUPPORT: 1.888.678.9427
Egress Port Egress Rewriting can be one of –
• Disable: No Egress rewrite.
• Enable: Rewrite enabled without remapping.
• Remap DP Unaware: DSCP from analyzer is remapped and frame is remarked with
remapped DSCP value. The remapped DSCP value is always taken from the ‘DSCP
Translation->Egress Remap DP0’ table.
• Remap DP Aware: DSCP from analyzer is remapped and frame is remarked with
remapped DSCP value. Depending on the DP level of the frame, the remapped DSCP
value is either taken from the ‘DSCP Translation->Egress Remap DP0’ table or from
the ‘DSCP Translation->Egress Remap DP1’ table.
Port Policing
This page allows you to configure the Policer settings for all switch ports.
Label Description
Port The port number for which the configuration below applies
Enable Controls whether the policer is enabled on this switch port.
Rate Controls the rate for the policer. The default value is 500. This value is restricted to
100-1000000 when the “Unit” is “kbps” or “fps”, and it is restricted to 1-3300 when the
“Unit” is “Mbps” or “kfps”.
Unit Controls the unit of measure for the policer rate as kbps, Mbps, fps or kfps . The default
value is “kbps”.