Installation Manual

INS_RLXE4GE24MODMS_REV– 1 Jul 2016 PAGE 53
INSTALLATION AND OPERATION MANUAL RLXE4GE24MODMS
TECH SUPPORT: 1.888.678.9427
Label Description
Ethertype for
customer S-Ports
This field specifies the ether type used for Custom S-ports. This is a global setting for
all the Custom S-ports.
Port This is the logical port number of this row.
Port type Port can be one of the following types: Unaware, Customer port (C-port), Service port
(S-port), Custom Service port (S-custom-port)
If Port Type is Unaware, all frames are classified to the Port VLAN ID and tags are not
removed.
Ingress Filtering Enable ingress filtering on a port by checking the box. This parameter affects VLAN
ingress processing. If ingress filtering is enabled and the ingress port is not a member
of the classified VLAN of the frame, the frame is discarded. By default, ingress filtering
is disabled (no check mark).
Frame Type Determines whether the port accepts all frames or only tagged/untagged frames. This
parameter affects VLAN ingress processing. If the port only accepts tagged frames,
untagged frames received on the port are discarded. By default, the field is set to All.
Port VLAN Mode Configures the Port VLAN Mode. The allowed values are None or Specific. This
parameter affects VLAN ingress and egress processing.
If None is selected, a VLAN tag with the classified VLAN ID is inserted in frames
transmitted on the port. This mode is normally used for ports connected to VLAN
aware switches. Tx tag should be set to Untag_pvid when this mode is used.
If Specific (the default value) is selected, a Port VLAN ID can be configured (see below).
Untagged frames received on the port are classified to the Port VLAN ID. If VLAN
awareness is disabled, all frames received on the port are classified to the Port VLAN
ID. If the classified VLAN ID of a frame transmitted on the port is different from the Port
VLAN ID, a VLAN tag with the classified VLAN ID is inserted in the frame.
Port VLAN ID Configures the VLAN identifier for the port. The allowed values are from 1 through
4095. The default value is 1.
Note: The port must be a member of the same VLAN as the Port VLAN ID.
Tx Tag Determines egress tagging of a port. Untag_pvid – All VLANs except the configured
PVID will be tagged. Tag_all – All VLANs are tagged. Untag_all – All VLANs are
untagged.