Installation Manual

INS_RLXE4GE24MODMS_REV– 1 Jul 2016 PAGE 25
INSTALLATION AND OPERATION MANUAL RLXE4GE24MODMS
TECH SUPPORT: 1.888.678.9427
Label Description
Delete Select this option to delete an existing IP route.
Network The destination IP network or host address of this route. Valid format is dotted decimal
notation or a valid IPv6 notation. A default route can use the value 0.0.0.0or IPv6 ::
notation.
Mask Length The destination IP network or host mask, in number of bits (prefix length). It defines
how much of a network address that must match, in order to qualify for this route.
Valid values are between 0 and 32 bits respectively 128 for IPv6 routes. Only a default
route will have a mask length of 0 (as it will match anything).
Gateway The IP address of the IP gateway. Valid format is dotted decimal notationor a valid IPv6
notation. Gateway and Network must be of the same type.
Next Hop VLAN
(Only for IPv6)
The VLAN ID (VID) of the specific IPv6 interface associated with the gateway.
The given VID ranges from 1 to 4094 and will be effective only when the
corresponding IPv6 interface is valid. If the IPv6 gateway address is link-local, it must
specify the next hop VLAN for the gateway. If the IPv6 gateway address is not link-
local, system ignores the next hop VLAN for the gateway.
RIP
The user can configure RIP Function on this page.
Label Description
Mode Indicates the RIP mode operation. Possible modes are:
Enabled: Enable RIP mode operation.
Disabled: Disable RIP mode operation.