Installation Manual

INS_RLXE4GE24MODMS_REV– 1 Jul 2016 PAGE 109
INSTALLATION AND OPERATION MANUAL RLXE4GE24MODMS
TECH SUPPORT: 1.888.678.9427
Event Selection
SYSLOG is the warning method supported by the system. Check the corresponding box to enable
system event warning method you wish to choose. Please note that the checkbox cannot be
checked when SYSLOG is disabled.
System Warning – Event Selection interface
The following table describes the labels in this screen.
Label Description
System Cold Start Alert when system restart
Power Status Alert when a power up or down
SNMP Authentication Failure Alert when SNMP authentication failure.
Redundant Ring Topology Change Alert when C-Ring topology changes.
Port Event
SYSLOG = event
› Disable
› Link Up
› Link Down
› Link Up & Link Down
Save Click to save the configurations.
Reset Click to reset the configurations.