Brochure

ManualsBrandsCOMNET ManualsSignal ExtendersNetWave Solar Power Ethernet Kit for Remote Locations with 6 Hour Peak Sunlight

LIMITED WARRANTY WWW.COMNET.NET TECH SUPPORT: 1.888.678.9427

FEATURES

› Warranty: 1 Year on Battery

2 Years on Solar Panel and Hardware

› Solar panel is designed with a heavy duty anodized frame

that is capable of withstanding high wind pressure, hail and

snow load.

› Solar Panel features outstanding low light performance

› High Efficiency Multicrystalline Photovoltaic Solar Panel

› Weatherproof powder coated steel enclosure that meets

NEMA 4X/IP65 weatherproofing standards

› Valve Regulated Sealed Lead Acid AGM Battery with great

low temperature performance to -40ºC

› 12 VDC Solar Charge Controller with LCD Screen, Intelligent

PWM Charging Mode, Adjustable charging and discharging

parameters

› 48 VDC Gigabit PoE Injector

› Intelligent Controller Featuring:

• Solar Controller Diagnostics LCD Display Supporting

Readout of Several Parameters Including System Charge/

Discharge and Battery Voltage

• Ampere Hours Monitoring of Accumulated Charge/

Discharge

• Intelligent PWM Charge Controller

• Automatic Temperature Compensation

• Adjustable Charge/Discharge Control Parameters

• Battery Low Voltage Disconnection

• Battery Reverse Connection Protection

• Overload/Short Circuit Protection

APPLICATIONS

› Remote Surveillance Cameras

› Wireless Perimeter Surveillance

› Temporary Network Surveillance Deployments

› Construction Site Network Access

The NetWave® NWKSP1 Solar off the grid power system is designed for applications where

a remote camera or wireless repeater is needed but power is not available or the cost to run

power is too expensive. NetWave Solar is a complete system for providing remote power

to edge communications equipment. The kit includes a high quality photovoltaic solar

panel, valve-regulated lead-acid battery, outdoor enclosure, solar charge controller, PoE

midspan injector and mounting hardware. The steel outdoor enclosure has a gasket hinged

lid with two tamper proof locks operated by a special key for high security. The enclosure and

solar panel can be mounted on a two to four inch pole or wall mounted with the included

mounting hardware. The included 30A solar charge controller supports an LCD screen for local

diagnostics and system health monitoring, Intelligent PWM charging mode and battery protection

from overcharge and over discharge while the battery provides outstanding deep cycle and cold

weather performance.

NWKSP1

Solar Power Ethernet Kit for Remote Locations

15 Watts Continuous Power System with 6 Hours of Peak Sunlight

803.2afBATTERIES

INCLUDED

Summary of content (2 pages)

PAGE 1
Solar Power Ethernet Kit for Remote Locations 15 Watts Continuous Power System with 6 Hours of Peak Sunlight NWKSP1 BATTERIES INCLUDED 803.2af The NetWave® NWKSP1 Solar off the grid power system is designed for applications where a remote camera or wireless repeater is needed but power is not available or the cost to run power is too expensive. NetWave Solar is a complete system for providing remote power to edge communications equipment.
PAGE 2
Solar Power Ethernet Kit for Remote Locations 15 Watts Continuous Power System with 6 Hours of Peak Sunlight NWKSP1 SPECIFICATIONS Controller Controller Type 12 to 24 V Solar Charge Controller Controller Self Consumption < 0.5 W IEEE 802.3af Compliant Power Injector Input Output Self Consumption 12 VDC 48 VDC @ .