Installation Manual

INS_NW7[E]/M_REV– 06/10/13 PAGE 20
INSTALLATION AND OPERATION MANUAL NW7[E]/M
TECH SUPPORT: 1.888.678.9427
9.4 Wireless (for Station Mode)
The following describes the parameters for a device operating in Station mode.
Figure 6: A summary in the Wireless section for a device operating as an 802.11 station.
SSID Displays the name of the wireless network that this station should be associated with.
Mode This is 'Client' if the device is in Station WDS mode.
Channel Shows the channel number and frequency that this station is using. Normally, it would
automatically select the same channel as the AP.
Bitrate This is the maximum bitrate supported by the radio in the current configuration.
MAC-Address States the MAC address of the device's radio.
BSSID This is the MAC address of the AP's radio.
Encryption Displays the wireless encryption used.
ACK Timeout Shows the maximum acknowledgment time in microseconds.
DFS Status If DFS is enabled, the AP automatically switches channel if radar is detected on the
current channel.
TX-CCQ Displays the transmission quality in %. A higher percentage means a better wireless
connection quality.
RX Rate Shows the receive bit rate of this station.
TX Rate Shows the transmit bit rate of this station.