Installation Manual

ManualsBrandsComnet ManualsFiber Optic TransmissionBi-directional Contact Closure Transceiver

INS_FDC10_REV–

09/25/15

PAGE 1

INSTALLATION AND OPERATION MANUAL

FDC10 Series

BI-DIRECTIONAL CONTACT CLOSURE TRANSCEIVER

The ComNet FDC10 Series bi-directional contact closure transceiver provides

bi-directional transmission of contact closure over one multimode or single mode

optical fiber. The transceiver has a contact input and a 0.5 amp contact output for each

channel. The bi-directional contact closure module has two relay outputs and one relay

input. One relay output follows the “relay input” at the remote end. When the remote

“relay input” is shorted, the local relay output is closed and vice-versa. The second relay

output is closed when “carrier” is detected from the remote end, this indicates that the

optical fiber is connected and that the remote end has power and is operating.

See Figures 1 – 2 and A - B for complete installation information.

This manual serves the following

ComNet Model Numbers:

FDC10M1A

FDC10M1B

FDC10S1A

FDC10S1B

FDC10RM1A

FDC10RM1B

FDC10RS1A

FDC10RS1B

Summary of content (4 pages)

PAGE 1
INSTALLATION AND OPERATION MANUAL FDC10 Series BI-DIRECTIONAL CONTACT CLOSURE TRANSCEIVER This manual serves the following ComNet Model Numbers: FDC10M1A FDC10M1B FDC10S1A FDC10S1B FDC10RM1A FDC10RM1B FDC10RS1A The ComNet FDC10 Series bi-directional contact closure transceiver provides bi-directional transmission of contact closure over one multimode or single mode optical fiber. The transceiver has a contact input and a 0.5 amp contact output for each channel.
PAGE 2
INSTALLATION AND OPERATION MANUAL FDC10 Series FIGURE 1 – Physical Features of FDC10R ComFit Unit 3 4 5 6 1 2 7 Table 1 – Physical Feature Descriptions Call-out Description Manual Reference 1 Contact Out Indicating LED See Table 4 - Indicating LEDs 2 Alarm Condition Indicating LED See Table 4 - Indicating LEDs 3 Optical Fiber Connection 4 Normally Open (NO) Relay Output Pair 5 Normally Open (NO) Optical Link Alarm Relay 6 Dry Contact Closure Input Pair 7 Power Connections TECH SUPPO
PAGE 3
INSTALLATION AND OPERATION MANUAL FDC10 Series FIGURE 2 – Physical Features of FDC10 Small Size Unit 2 4 5 6 1 3 7 Table 2 – Physical Feature Descriptions Call-out Description Manual Reference 1 Optical Fiber Connection 2 Relay Contact Indicating LED See Table 4 - Indicating LEDs 3 Carrier Detect Indicating LED See Table 4 - Indicating LEDs 4 Normally Open (NO) Relay Output Pair 5 Normally Open (NO) Optical Link Alarm Relay 6 Dry Contact Closure Input Pair 7 Power Connections See Tab
PAGE 4
INSTALLATION AND OPERATION MANUAL INSTALLATION CONSIDERATIONS The FDC10R is supplied as a ComFit Standalone / Rack module. The FDC10 is supplied as a Standalone / Surface Mount module. Units should be installed in dry locations protected from extremes of temperature and humidity.