User Manual

98
Spanning Tree Commands Set
Netstar Commands
Level
Description
Example
spanning-tree enable
G
Enable spanning tree
switch(config)#spanning-tree
enable
spanning-tree priority
[0~61440]
G
Configure spanning tree
priority parameter
switch(config)#spanning-tree
priority 32767
spanning-tree max-age
[seconds]
G
Use the spanning-tree
max-age global
configuration command to
change the interval
between messages the
spanning tree receives
from the root switch. If a
switch does not receive a
bridge protocol data unit
(BPDU) message from the
root switch within this
interval, it recomputed the
Spanning Tree Protocol
(STP) topology.
switch(config)#spanning-tree
max-age 15
spanning-tree
hello-time [seconds]
G
Use the spanning-tree
hello-time global
configuration command to
specify the interval
between hello bridge
protocol data units
(BPDUs).
switch(config)#spanning-tree
hello-time 3