Manualshelf

System information

ManualsBrandsComnet ManualsComputer equipmentCWGE2FE8MSPOE
21222324252627282930
14
Desktop Installation
Set the switch on a sufficiently large flat space with a power outlet nearby. The surface
where you put the switch should be clean, smooth, level and sturdy. Make sure there is
enough space around the switch to allow air circulation.
Attaching Rubber Pads
A. Make sure mounting surface on the bottom of the switch is grease and dust free.
B. Remove adhesive backing from your Rubber Pads.
C. Apply the Rubber Pads to each corner on the bottom of the switch. These footpads can
prevent the switch from shock/vibration.
Power On
Connect the DC jack to the power socket on the rear panel of the switch. Connect the other
side of power plug to the power outlet. The power adaptor works with voltage range of AC in
the 100-240V
AC
/Frequency of 50~60Hz for CWGE2FE8MSPOE Managed Switch. Check
the power indicator on the front panel to see if power is properly supplied.