System information

44
State Activity
When you have set up the LACP aggregator, you can configure port state activity. You
can mark or un-mark the port. When you mark the port and select button the
port state activity will change to Active. Opposite is Passive.
 Active: The port automatically sends LACP protocol packets.
 Passive: The port does not automatically send LACP protocol packets, and responds
only if it receives LACP protocol packets from the opposite device.
[NOTE]
1. A link having either two active LACP ports or one active port can perform dynamic
LACP trunk.
2. A link that has two passive LACP ports will not perform dynamic LACP trunk
because both ports are waiting for an LACP protocol packet from the opposite
device.
3. If you are the active LACP’s actor, after you have selected trunk port, the active
status will be created automatically.
Port Trunk – State Activity interface