Specifications

INS_CWGE28FX4TX24MS_REV– 08/31/12 PAGE 21
INSTALLATION AND OPERATION MANUAL CWGE28FX4TX24MS
TECH SUPPORT: 1.888.678.9427
LLDP Neighbor Information
This page provides a status overview for all LLDP neighbors. The displayed table contains a row
for each port on which an LLDP neighbor is detected. The columns hold the following information:
Label Description
Local Port The port on which the LLDP frame was received.
Chassis ID The Chassis ID is the identification of the neighbor’s LLDP frames.
Remote Port ID The Remote Port ID is the identification of the neighbor port.
System Name System Name is the name advertised by the neighbor unit.
Port Description Port Description is the port description advertised by the neighbor unit.
System
Capabilites
System Capabilities describes the neighbor unit’s capabilities. The possible
capabilities are:
1. Other
2. Repeater
3. Bridge
4. WLAN Access Point
5. Router
6. Telephone
7. DOCSIS cable device
8. Station only
9. Reserved
When a switch capability is enabled, the capability is followed by (+). If the
capability is disabled, the capability is followed by (-).
Management
Address
Management Address is the next unit’s address that is used for higher layer
entities to assist in the network nodes discovery process by the network
management. This could identify the neighbor’s IP address.
Refresh Click to immediately refresh the page .
Auto-Refresh Check this box to enable an automatic refresh of the page at regular intervals.