Installation Manual
Table Of Contents
- About This Guide
- Overview
- Hardware Overview
- Ethernet Cables
- WEB Management
- Configuration by Web Browser
- About Web-based Management
- Basic Setting
- System Information
- Admin & Password
- Auth Method
- IP Setting
- HTTPS
- SSH
- LLDP
- Backup/Restore Configuration
- Firmware Update
- DHCP Server
- Port Setting
- Port Trunk
- LACP
- Redundancy
- MSTP
- STP
- VLAN
- VLAN Setting Example
- SNMP
- Traffic Prioritization
- Multicast
- Security
- AAA
- RADIUS Overview
- Warning
- System Warning
- Monitor and Diag
- Port Statistic
- System Log Information
- Cable Diagnostics
- SFP Monitor
- Ping
- Syncronization-PTP
- PoE Configuration
- Status
- Factory Defaults
- System Reboot
- Configuration by Web Browser
- Command Line Interface Management
- Technical Specifications
INS_CWGE26FX2TX24MSPOE_REV– 5 Mar 2014 PAGE 70
INSTALLATION AND OPERATION MANUAL CWGE26FX2TX24MSPOE
TECH SUPPORT: 1.888.678.9427
Port Shaping
This page provides an overview of QoS Egress Port Shapers for all switch ports.
Label Description
Port The logical port for the settings contained in the same row.
Click on the port number in order to configure the shapers.
Mode Shows “disabled” or actual queue shaper rate – e.g. “800 Mbps”.
Qn Shows “disabled” or actual port shaper rate – e.g. “800 Mbps”.
DSCP Based QoS
This page allows you to configure the basic QoS DSCP based QoS Ingress Classification settings
for all switches.
Label Description
DSCP Maximum number of supported DSCP values are 64.
Trust Controls whether a specific DSCP value is trusted. Only frames with trusted DSCP
values are mapped to a specific QoS class and Drop Precedence Level. Frames with
untrusted DSCP values are treated as a non-IP frame.
QoS Class QoS class value can be any of (0-7)
DPL Drop Precedence Level (0-1)