Installation Manual
Table Of Contents
- About This Guide
- Overview
- Hardware Overview
- Ethernet Cables
- WEB Management
- Configuration by Web Browser
- About Web-based Management
- Basic Setting
- System Information
- Admin & Password
- Auth Method
- IP Setting
- HTTPS
- SSH
- LLDP
- Backup/Restore Configuration
- Firmware Update
- DHCP Server
- Port Setting
- Port Trunk
- LACP
- Redundancy
- MSTP
- STP
- VLAN
- VLAN Setting Example
- SNMP
- Traffic Prioritization
- Multicast
- Security
- AAA
- RADIUS Overview
- Warning
- System Warning
- Monitor and Diag
- Port Statistic
- System Log Information
- Cable Diagnostics
- SFP Monitor
- Ping
- Syncronization-PTP
- PoE Configuration
- Status
- Factory Defaults
- System Reboot
- Configuration by Web Browser
- Command Line Interface Management
- Technical Specifications
INS_CWGE26FX2TX24MSPOE_REV– 5 Mar 2014 PAGE 65
INSTALLATION AND OPERATION MANUAL CWGE26FX2TX24MSPOE
TECH SUPPORT: 1.888.678.9427
DP level Controls the default Drop Precedence Level.
All frames are classified to a DP level.
If the port is VLAN aware and the frame is tagged, then the frame is classified to a DP
level that is equal to the DEI value in the tag. Otherwise the frame is classified to the
default DP level.
If the port is VLAN aware, the frame is tagged and Tag Class is enabled, then the
frame is classified to a DP level that is mapped from the PCP and DEI value in the tag.
Otherwise the frame is classified to the default DP level.
The classified DP level can be overruled by a QCL entry.
PCP Controls the default PCP value.
All frames are classified to a PCP value.
If the port is VLAN aware and the frame is tagged, then the frame is classified to the
PCP value in the tag. Otherwise the frame is classified to the default PCP value.
DEI Controls the default DEI value.
All frames are classified to a DEI value.
If the port is VLAN aware and the frame is tagged, then the frame is classified to the
DEI value in the tag. Otherwise the frame is classified to the default DEI value.
Tag Class Shows the classification mode for tagged frames on this port.
Disabled: Use default QoS class and DP level for tagged frames.
Enabled: Use mapped versions of PCP and DEI for tagged frames.
Click on the mode in order to configure the mode and/or mapping.
Note: This setting has no effect if the port is VLAN unaware. Tagged frames received
on VLAN unaware ports are always classified to the default QoS class and DP level.
DSCP Based Click to Enable DSCP Based QoS Ingress Port Classification.