Installation Manual

INS_CWGE26FX2TX24MSPOE_REV– 5 Mar 2014 PAGE 59
INSTALLATION AND OPERATION MANUAL CWGE26FX2TX24MSPOE
TECH SUPPORT: 1.888.678.9427
Trap Inform
Timeout
(seconds)
Indicates the SNMP trap inform timeout. The allowed range is 0 to 2147.
Trap Inform
Retry Times
Indicates the SNMP trap inform retry times. The allowed range is 0 to 255.
Trap Probe
Security Engine
ID
Indicates the SNMP trap probe security engine ID mode of operation. Possible values
are:
Enabled: Enable SNMP trap probe security engine ID mode of operation.
Disabled: Disable SNMP trap probe security engine ID mode of operation.
Trap Security
Engine ID
Indicates the SNMP trap security engine ID. SNMPv3 sends traps and informs using
USM for authentication and privacy. A unique engine ID for these traps and informs
is needed. When “Trap Probe Security Engine ID” is enabled, the ID will be probed
automatically. Otherwise, the ID specified in this field is used. The string must contain
an even number between 10 and 64 hexadecimal digits, but all-zeros and all-’F’s are
not allowed.
Trap Security
Name
Indicates the SNMP trap security name. SNMPv3 traps and informs using USM for
authentication and privacy. A unique security name is needed when traps and informs
are enabled.
SNMP-Communities
Configure SNMPv3 communities table on this page. The entry index key is Community.
Label Description
Delete Check to delete the entry. It will be deleted during the next save.
Community Indicates the community access string to permit access to SNMPv3 agent. The allowed
string length is 1 to 32, and the allowed content is the ASCII characters from 33 to 126.
Source IP Indicates the SNMP access source address.
Source Mask Indicates the SNMP access source address mask.