Installation Manual
Table Of Contents
- About This Guide
- Overview
- Hardware Overview
- Ethernet Cables
- WEB Management
- Configuration by Web Browser
- About Web-based Management
- Basic Setting
- System Information
- Admin & Password
- Auth Method
- IP Setting
- HTTPS
- SSH
- LLDP
- Backup/Restore Configuration
- Firmware Update
- DHCP Server
- Port Setting
- Port Trunk
- LACP
- Redundancy
- MSTP
- STP
- VLAN
- VLAN Setting Example
- SNMP
- Traffic Prioritization
- Multicast
- Security
- AAA
- RADIUS Overview
- Warning
- System Warning
- Monitor and Diag
- Port Statistic
- System Log Information
- Cable Diagnostics
- SFP Monitor
- Ping
- Syncronization-PTP
- PoE Configuration
- Status
- Factory Defaults
- System Reboot
- Configuration by Web Browser
- Command Line Interface Management
- Technical Specifications
INS_CWGE26FX2TX24MSPOE_REV– 5 Mar 2014 PAGE 29
INSTALLATION AND OPERATION MANUAL CWGE26FX2TX24MSPOE
TECH SUPPORT: 1.888.678.9427
Port Setting
Port Control
This page displays current port configurations. Ports can also be configured here.
Label Description
Port This is the logical port number for this row.
Link The current link state is displayed graphically. Green indicates the link is up and red
that it is down.
Current Link
Speed
Provides the current link speed of the port.
Configured Link
Speed
Selects any available link speed for the given switch port. Only speeds supported by
the specific port is shown. Possible speeds are:
Disabled – Disables the switch port operation.
Auto – Cu port auto negotiating speed with the link partner and selects the highest
speed that is compatible with the link partner.
10Mbps HDX – Force the Cu port to 10Mbps half duplex mode.
10Mbps FDX – Force the Cu port to 10Mbps full duplex mode.
100Mbps HDX – Force the Cu port to 100Mbps half duplex mode.
100Mbps FDX – Force the Cu port to 100Mbps full duplex mode.
1Gbps FDX – Force the Cu port to 1Gbps full duplex mode.
100-FX – SFP port in 100-FX speed. Cu port disabled.
1000-X – SFP port in 1000-X speed. Cu port disabled.
1000-X_AMS – Port in AMS mode with SFP preferred. SFP port in 1000-X speed. Cu
port in Auto mode.
Flow Control When Auto Speed is selected for a port, this section indicates the flow control
capability that is advertised to the link partner.
When a fixed-speed setting is selected, that is what is used. The Current Rx column
indicates whether pause frames on the port are obeyed, and the Current Tx column
indicates whether pause frames on the port are transmitted. The Rx and Tx settings are
determined by the result of the last Auto-Negotiation.
Check the configured column to use flow control. This setting is related to the setting
for Configured Link Speed.
Maximum Frame Enter the maximum frame size allowed for the switch port, including FCS. The allowed
range is 1518 bytes to 9600 bytes.