User Manual

INS_CNGEMC4+2[POE][HO]/M 09/08/20 PAGE 27
INSTALLATION AND OPERATION MANUAL CNGEMC4+2[POE][HO]/M
TECH SUPPORT: 1.888.678.9427
Port Guardian
The Port Guardian feature provides a high security managed port lock out mode and when enabled
will power down the port as soon as a link loss status is detected when a cable is disconnected. This
provides high security against network attack by an intruder who accesses the edge device and
disconnects it to then try and connect their own intrusion device (laptop, network sniffer etc.).
To reset a port from a lock out state the network administrator can issue an SNMP reset or can reset
a port by using the CLI via the USB serial port. In PoE models a reset can also be initiated by using
one of the contact inputs.
Label Description
Enable Enable the Port Guardian feature
Port Enable Enable the Port Guardian feature on each port
Initial Port Power Down If enabled, then any ports which are enabled for Port Guardian will be put into
lock out state in the event of a power cycle. These ports would then need to
be re-enabled by the administrator after a power cycle event.
Power Cycle Reset If enabled, any ports which were in lock out state will be re-enabled after a
power cycle
Port Fault Status Displays the current port state. A “faulted” message indicates the port is
disabled by Port Guardian
Clear Port Fault Status Check and apply to clear a port faulted on a port