System information

INS_CNGE3FE7MS4_REV– Rev. 4.30.14 PAGE 96
INSTALLATION AND OPERATION MANUAL CNGE3FE7MS4
TECH SUPPORT: 1.888.678.9427
8021x portstate
[disable | reject | accept |
authorize]
I Use the 802.1x port state interface
configuration command to set the
state of the selected port.
switch(config)#interface fastethernet 3
switch(config-if)#8021x portstate
accept
show 8021x E Display a summary of the 802.1x
properties and also the port sates.
switch>show 8021x
no 8021x G Disable 802.1x function switch(config)#no 8021x
Commands Set List—TFTP command set
Commands Level Description Example
backup flash:backup_cfg G Save configuration to TFTP and
need to specify the IP of TFTP
server and the file name of image.
switch(config)#backup flash:backup_
cfg
restore flash:restore_cfg G Get configuration from TFTP
server and need to specify the IP
of TFTP server and the file name
of image.
switch(config)#restore flash:restore_cfg
upgrade flash:upgrade_
fw
G Upgrade firmware by TFTP and
need to specify the IP of TFTP
server and the file name of image.
switch(config)#upgrade lash:upgrade_
fw
Commands Set List—SYSLOG, SMTP, EVENT command set
Commands Level Description Example
systemlog ip
[IP address]
G Set System log server IP address. switch(config)# systemlog ip
192.168.1.10 0
systemlog mode
[client|server|both]
G Specified the log mode switch(config)# systemlog mode both
show systemlog E Display system log. Switch>show systemlog
show systemlog P Show system log client & server
information
switch#show systemlog
no systemlog G Disable systemlog functon switch(config)#no systemlog
smtp enable G Enable SMTP function switch(config)#smtp enable
smtp serverip
[IP address]
G Configure SMTP server IP switch(config)#smtp serverip
192.168.1.5
smtp authentication G Enable SMTP authentication switch(config)#smtp authentication
smtp account
[account]
G Configure authentication account switch(config)#smtp account User