System information

INS_CNGE3FE7MS4_REV– Rev. 4.30.14 PAGE 87
INSTALLATION AND OPERATION MANUAL CNGE3FE7MS4
TECH SUPPORT: 1.888.678.9427
Commands Set List—Trunk command set
Commands Level Description Example
aggregator priority
[1to65535]
G Set port group system priority switch(config)#aggregator priority 22
aggregator activityport
[Port Numbers]
G Set activity port switch(config)#aggregator activityport
2
aggregator group
[GroupID] [Port-list]
lacp
workp
[Workport]
G Assign a trunk group with LACP
active.
[GroupID] :1to3
[Port-list]:Member port list,
This parameter could be a port
range(ex.1-4) or a port list separate
by a comma(ex.2, 3, 6)
[Workport]: The amount of work
ports, this value could not be less
than zero or be large than the
amount of member ports.
switch(config)#aggregator group 1 1-4
lacp workp 2
or
switch(config)#aggregator group 2
1,4,3 lacp workp 3
aggregator group
[GroupID] [Port-list]
nolacp
G Assign a static trunk group.
[GroupID] :1to3
[Port-list]:Member port list,
This parameter could be a port
range(ex.1-4) or a port list separate
by a comma(ex.2, 3, 6)
switch(config)#aggregator group 1 2-4
nolacp
or
switch(config)#aggreator group 1 3,1,2
nolacp
show aggregator P Show the information of trunk
group
switch#show aggregator
no aggregator lacp
[GroupID]
G Disable the LACP function of trunk
group
switch(config)#no aggreator lacp 1
no aggregator group
[GroupID]
G Remove a trunk group switch(config)#no aggreator group 2