System information

INS_CNGE3FE7MS4_REV– Rev. 4.30.14 PAGE 86
INSTALLATION AND OPERATION MANUAL CNGE3FE7MS4
TECH SUPPORT: 1.888.678.9427
bandwidth out
[Value]
I Set interface output bandwidth.
Rate Range is from 100 kbps to
102400 kbps or to 256000 kbps
for giga ports,
and zero means no limit.
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth out 100
show bandwidth I Show interfaces bandwidth
control
switch(config)#interface fastEthernet 2
switch(config-if)#show bandwidth
state
[Enable | Disable]
I Use the state interface
configuration command to specify
the state mode of operation for
Ethernet ports. Use the disable
form of this command to disable
the port.
switch(config)#interface fastEthernet 2
switch(config-if)#state Disable
show interface
configuration
I show interface configuration
status
switch(config)#interface fastEthernet
2 switch(config-if)#show interface
configuration
show interface status I show interface actual status switch(config)#interface fastEthernet 2
switch(config-if)#show interface status
show interface
accounting
I show interface statistic counter switch(config)#interface fastEthernet
2 switch(config-if)#show interface
accounting
no accounting I Clear interface accounting
information
switch(config)#interface fastEthernet 2
switch(config-if)#no accounting