System information

INS_CNGE3FE7MS4_REV– Rev. 4.30.14 PAGE 85
INSTALLATION AND OPERATION MANUAL CNGE3FE7MS4
TECH SUPPORT: 1.888.678.9427
Commands Set List—Port Commands Set
Commands Level Description Example
interface fastEthernet
[Portid]
G Choose the port for modification. switch(config)#interface fastEthernet 2
duplex
[full | half]
I Use the duplex configuration
command to specify the duplex
mode of operation for Fast
Ethernet.
switch(config)#interface fastEthernet 2
switch(config-if)#duplex full
speed
[10|100|1000|auto]
I Use the speed configuration
command to specify the speed
mode of operation for Fast
Ethernet., the speed can’t be set
to 1000 if the port isn’t a giga
port..
switch(config)#interface fastEthernet 2
switch(config-if)#speed 100
flowcontrol mode
[Symmetric|Asymmetric]
I Use the flowcontrol configuration
command on Ethernet ports
to control traffic rates during
congestion.
switch(config)#interface fastEthernet 2
switch(config-if)#flowcontrol mode
Asymmetric
no flowcontrol I Disable flow control of interface switch(config-if)#no flowcontrol
security enable I Enable security of interface switch(config)#interface fastEthernet 2
switch(config-if)#security enable
no security I Disable security of interface switch(config)#interface fastEthernet 2
switch(config-if)#no security
bandwidth type all I Set interface ingress limit frame
type to “accept all frame”
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type all
bandwidth type
broadcast-multicast-
flooded-unicast
I Set interface ingress limit frame
type to “accept broadcast,
multicast, and flooded unicast
frame”
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type
broadcast-multicast-flooded-unicast
bandwidth type
broadcast-multicast
I Set interface ingress limit frame
type to “accept broadcast and
multicast frame”
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type
broadcast-multicast
bandwidth type
broadcast-only
I Set interface ingress limit frame
type to “only accept broadcast
frame”
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type
broadcast-only
bandwidth in
[Value]
I Set interface input bandwidth.
Rate Range is from 100 kbps to
102400 kbps or to 256000 kbps
for giga ports, and zero means no
limit.
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth in 100