System information

INS_CNGE3FE7MS4_REV– Rev. 4.30.14 PAGE 26
INSTALLATION AND OPERATION MANUAL CNGE3FE7MS4
TECH SUPPORT: 1.888.678.9427
IP Setting
You can configure the IP Settings and DHCP client function through IP configuration.
IP Configuration interface
Label Description
DHCP Client To enable or disable the DHCP client function. When DHCP client
function is enabling, the switch will be assigned the IP address
from the network DHCP server. The default IP address will be
replaced by the IP address that the DHCP server has assigned.
After selecting Apply button, a popup dialog shows up to inform
when the DHCP client is enabling. The current IP will lose and you
should find a new IP on the DHCP server.
IP Address Assign the IP address that the network is using. If the DHCP client
function is enabled, you do not need to assign the IP address. The
network DHCP server will assign the IP address for the switch and
it will be display in this column. The default IP is 192.168.10.1
Subnet Mask Assign the subnet mask of the IP address. If DHCP client function
is enabling, you do not need to assign the subnet mask
Gateway Assign the network gateway for the switch. The default gateway is
192.168.10. 254
DNS1 Assign the primary DNS IP address
DNS2 Assign the secondary DNS IP address
Apply Select Apply to activate the configurations.