System information

INS_CNGE2FE8MSPOE+_REV–
12/20/12 PAGE 88
INSTALLATION AND OPERATION MANUAL CNGE2FE8MSPOE+
TECH SUPPORT: 1.888.678.9427
Commands Set List—Port Commands Set
Commands Level Description Example
interface fastEthernet
[Portid]
G Choose the port for modification. switch(config)#interface fastEthernet 2
duplex
[full | half]
I Use the duplex configuration
command to specify the duplex
mode of operation for Fast Ethernet.
switch(config)#interface fastEthernet 2
switch(config-if)#duplex full
speed
[10|100|1000|auto]
I Use the speed configuration
command to specify the speed mode
of operation for Fast Ethernet., the
speed can’t be set to 1000 if the port
isn’t a giga port..
switch(config)#interface fastEthernet 2
switch(config-if)#speed 100
flowcontrol mode
[Symmetric|Asymmetric]
I Use the flowcontrol configuration
command on Ethernet ports
to control traffic rates during
congestion.
switch(config)#interface fastEthernet 2
switch(config-if)#flowcontrol mode
Asymmetric
no flowcontrol I Disable flow control of interface switch(config-if)#no flowcontrol
security enable I Enable security of interface switch(config)#interface fastEthernet 2
switch(config-if)#security enable
no security I Disable security of interface switch(config)#interface fastEthernet 2
switch(config-if)#no security
bandwidth type all I Set interface ingress limit frame type
to “accept all frame”
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type all
bandwidth type broadcast-
multicast-flooded-unicast
I Set interface ingress limit frame type
to “accept broadcast, multicast, and
flooded unicast frame”
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type
broadcast-multicast-flooded-unicast
bandwidth type broadcast-
multicast
I Set interface ingress limit frame type
to “accept broadcast and multicast
frame”
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type
broadcast-multicast
bandwidth type broadcast-
only
I Set interface ingress limit frame type
to “only accept broadcast frame”
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth type
broadcast-only
bandwidth in
[Value]
I Set interface input bandwidth. Rate
Range is from 100 kbps to 102400
kbps or to 256000 kbps for giga
ports, and zero means no limit.
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth in 100
bandwidth out
[Value]
I Set interface output bandwidth. Rate
Range is from 100 kbps to 102400
kbps or to 256000 kbps for giga
ports,
and zero means no limit.
switch(config)#interface fastEthernet 2
switch(config-if)#bandwidth out 100
show bandwidth I Show interfaces bandwidth control switch(config)#interface fastEthernet 2
switch(config-if)#show bandwidth