Specifications

INS_CNGE28FX4TX24MSPOE+_REV–
08/31/12 PAGE 24
INSTALLATION AND OPERATION MANUAL CNGE28FX4TX24MSPOE+
Tech SupporT: 1.888.678.9427
LLDP Neighbor Information
This page provides a status overview for all LLDP neighbors. The displayed table contains a row
for each port on which an LLDP neighbor is detected. The columns hold the following information:
Label Description
Local Port The port on which the LLDP frame was received.
Chassis ID The Chassis ID is the identification of the neighbor’s LLDP frames.
Remote Port ID The Remote Port ID is the identification of the neighbor port.
System Name System Name is the name advertised by the neighbor unit.
Port Description Port Description is the port description advertised by the neighbor
unit.
System
Capabilites
System Capabilities describes the neighbor unit’s capabilities. The
possible capabilities are:
1. Other
2. Repeater
3. Bridge
4. WLAN Access Point
5. Router
6. Telephone
7. DOCSIS cable device
8. Station only
9. Reserved
When a capability is enabled, the capability is followed by (+). If the
capability is disabled, the capability is followed by (-).
Management
Address
Management Address is the neighbor unit’s address that is used
for higher layer entities to assist the discovery by the network
management. This could for instance hold the neighbor’s IP address.
Refresh Select to refresh the page immediately.
Auto-refresh Check this box to enable an automatic refresh of the page at regular
intervals.